![]() ![]() ![]() Intensity and on the solution of the first increment of the step or can be The initial damping factors will be recalculated based on the declared damping Set CONTINUE= NO (default) to specify that this step will not carry over theĭamping factors from the results of the preceding general step. This parameter must be used in conjunction with the STABILIZE parameter (see If this parameter is omitted but the STABILIZE parameter is included with the default value of dissipatedĮnergy fraction, the adaptive automatic damping algorithm will be activated If this parameter is included without a specified value, ![]() If this parameter is set equal to zero, the adaptive automaticĭamping algorithm is not activated a constant damping factor will be used The step based on the convergence history and the value of ALLSDTOL. This damping factor will then be adjusted through The initial damping factor is specified via the STABILIZE parameter or the FACTOR parameter. Maximum allowable ratio of the stabilization energy to the total strain energy. Include this parameter to indicate that an adaptive automatic dampingĪlgorithm will be activated in this step. INELASTIC HEAT FRACTION option has been specified. Parameter is relevant only for isotropic metal plasticity materials with a Include this parameter to perform an adiabatic stress analysis. Optional parameters for a general static analysis ADIABATIC ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |